BannerFrame Installation Instructions
1. Determine Banner Size and mark dimension perimeter on install surface
2. Install base channel 1.5” around perimeter
3. Install Banner by pulling BannerSpring tips into pre-marked banner holes (see banner prep instructions)
4. Snap onBannerFrame CoverSections,Seam Coversand Corner Caps over Base channel. Light screwsasneeded.
BannerFrame Fabric Graphic Print & Finishing Instructions
Step 1: Mark theMark-line
Print or sketch a thin line around the entire banner perimeter, ¾” inside the banner edge.
Step 2: Mark holes on the 4 Sides*
BannerFrame 4’ sections are either End-Sections or Middle-Sections.
End Sections come pre-loaded with (5) springs. Middle Sections come pre-loaded with (4) springs. For either section type, Mark and punch 1/8” holes along the Mark-line (3/4” in from banner edge) using the correlating spacing for each section.
Substrate: Lind SignSpring Group suggests 7 oz. for vinyl for most applications. However, SignSpring performs well on heavier vinyl along with mesh, backlit, PE and most fabric graphic substrates.
Finishing: For best results, edges should be stitched, hemmed, or welded to avoid edge-curl. Do not use grommets.
Printing: Artwork and Final printing should include a mark-line bordering the entire graphic, ¾” inside the banner edge. The holes may also be marked or inserted as part of the printing process. If using BannerFrame cover sections, remember that approximately 3” of vinyl perimeter will be covered by BannerFrame Cover. As such, do not print AD copy within 5” of edge.