Step 1: Determine Banner Size and mark dimension perimeter on install surface.

Determine banner sizeMark perimeter on install surface

Step 2: Install base channel 1.5”around perimeter.

Install base channel

Step 3: Install Banner by pulling BannerSpring tips into pre marked banner holes (see banner prep instructions).

Install bannerPull spring tips into pre-marked holesInstalled banner without frame cover

Step 4: Snap on BannerFrame Cover Sections, Seam Covers and Corner Caps over Base channel. Light screws as needed.

Screws as neededSeam coverCorner coverFinished banner installationBannerFrame diagram

 

Step 1: Mark the Mark-line Print or sketch a thin line around the entire banner perimeter, ¾” inside the banner edge.

BannerFrame fabric graphic print and finishing diagram

Step 2: Mark holes on the 4 Sides* BannerFrame 4’ sections are either End-Sections or Middle-Sections. End Sections come pre-loaded with (5) springs. Middle Sections come pre-loaded with (4) springs. For either section type, Mark and punch 1/8” holes along the Mark-line (3/4” in from banner edge) using the correlating spacing for each section.

4' End Section:

End section diagram

4' Middle Section:

Middle section diagram

Corner:

Corner diagram

Substrate: Lind SignSpring Group suggests 7 oz. for vinyl for most applications. However, SignSpring performs well on heavier vinyl along with mesh, backlit, PE and most fabric graphic substrates.

Finishing: For best results, edges should be stitched, hemmed, or welded to avoid edge-curl. Do not use grommets.

Printing: Artwork and Final printing should include a mark-line bordering the entire graphic, ¾” inside the banner edge. The holes may also be marked or inserted as part of the printing process. If using BannerFrame cover sections, remember that approximately 3” of vinyl perimeter will be covered by BannerFrame Cover. As such, do not print AD copy within 5” of edge.

Lind SignSpring Group provides graphic fulfillment that includes pre-markings and protrusions to assure efficient installation and flawless results.

BannerSpring installation diagram

Step 1: Chalk banner perimeter.

Step 2: Mark springs using the spacing chart. Install BannerSprings 2 inches off chalk perimeter edges.

Step 3: Install banner by pulling BannerSpring tips into pre-marked banner holes (see banner prep instructions).

Example spacing is for 4 foot x 8 foot banner.