Production Instructions

BannerSpring Production Guidelines

Step 1: Mark the Mark-line

Print or sketch a thin line around the entire banner perimeter, ¾” inside the banner edge.

Step 2: Mark and Insert Corners Holes

Mark and punch 1/8” holes as shown below for each corner. Holes are always 3/4” in from Banner edges and should occur on the Mark-Line described above.

Step 3: Mark holes on the 4 Sides

Mark and punch 1/8” holes along the Mark-line (3/4” in from banner edge) using the prescribed spring spacing 1’ intervals.

schematic of the banner corners of the Lind SignSpring system
guidelines to installing a banner on the Lind SignSpring system

10'x 25' Banner Example

Fabric Edge Finishing: stitched, hemmed, or welded suggested.
Mark-Lines: Printed along entire perimeter ¾” from banner edge.
Ad Copy: Do not print within 4” of edges.
Side Holes: See size chart to determine spring count and spacing.
Substrate: Lind SignSpring Group suggests 8 oz mesh for any project over 100 square feet. For under 100 square feet, 7 oz vinyl or mesh is recommended.
Finishing: For best results, edges should be stitched, hemmed, or welded to avoid edge-curl. Do not use grommets.
Printing: Artwork and Final printing should include a mark-line bordering the entire graphic, ¾” inside the banner edge. The holes may also be marked or inserted as part of the printing process. If using BannerFrame, remember that approximately 3” of vinyl perimeter will be covered by BannerFrame Cover. As such, do not print Ad copy within 3” of edge.
Lind SignSpring Group provides graphic fulfillment that includes pre-markings and protrusions to assure efficient installation and flawless results.

Notice about installation of the Lind BannerSpring system

BannerFrame Production Guidelines

Step 1: Mark the Mark-line

Print or sketch a thin line around the entire banner perimeter, 3⁄4” inside the banner edge. All punch holes should be placed on mark-line.

Step 2: Mark Punch-Holes around Banner Perimeter on Mark-Line On Each of the 4 sides.....

Place your first dot 1” in from the banner edge along the Mark-Line
nPlace your second dot 6” in from the banner edge also along the Mark-Line
nAll additional dots should be spaced at 1’ intervals until you reach the end of the banner where the dots should be 6” and 1” from the edge respectively.

How to install a banner into the Lind SignSpring system
an example of how to install a 8' x 24' banner into the Lind SignSpring system

Substrate: Lind SignSpring Group suggests 8 oz mesh for any project over 100 square feet. For under 100 square feet, 7 oz vinyl or mesh is recommended.
Finishing: For best results, edges should be stitched, hemmed, or welded to avoid edge-curl. Do not use grommets.
Printing: Artwork and Final printing should include a thin printed line bordering the entire graphic, 3⁄4” inside the banner edge. The holes may also be marked or inserted as part of the printing process. BannerFrame Cover Sections will cover 3’’ around the Banner perimeter. Avoid printing copy within 5” of Graphic Edge.

Notice about installation of the Lind BannerSpring system
Specs of a Single Sheet Billboard Installation System